Specifications for Compression Springs:
  1. Notice that this form is for Metric Units only if you would like English Units instead please click Here.
  2. Specify only those parameters which are absolutely important for the correct functioning of the spring.

  3. Do not attempt to specify every possible dimension of the spring. This will only increase the cost unnecessarily.

    Depending upon the loading characteristics, some of the dimensions may have to be left open to allow for manufacturing compensation.

  4. Based on our experience, the best possible spring design can be obtained by the following steps.

    A) Fill in the data below and forward it to us by clicking on the "Submit" button.

    B) We will then calculate for you the best possible spring design.

    C) We will recommend to you the data and specifications your drawing should contain.

* indicates a required field
Contact Information:
Name:*
E-Mail:*
Company:*
Phone:*
Fax:
 
Type of Assistance:
Design:
Quantity to Quote:
If Quantity to Quote Please indicate EAU:
 
Fill in Applicable Data Only:
To work in   mm diameter hole
To work over mm diameter shaft
 
Lowest compressed height in operation mm
Lowest compressed height during assembly mm
 
Load (P1)   N +/-   N at Length (L1)   mm
Load (P2)   N +/-     N at Length (L2)   mm
 
Rate (R)   N/mm +/-   N/mm when tested between the
length of   mm and     mm
 
Solid height maximum mm
 
Direction of coiling:   Right Hand
  Left Hand
  Optional
 
Types of ends:   open/ground
  open/not ground
  closed/ground
  closed/not ground
 

Compression Spring Diagram

Compression Spring Diagram
 
Operational Requirements:
Spring is always statically loaded to mm
 
Spring operates dynamically between the lengths of   mm and
  mm. A total of   cycles are expected before failure.
 
Speed of cycles Cycles Per Minute
 
Maximum temperature during operation °C
 
Operating environment of spring  
 
Load loss requirement  
 
Special Requirements:
Squareness if less than 3 degrees  
 
Plating  
 
Shot peening  
 
Heat set  
 
Set removal  
 
Other:  
 
Suggested Design Data:
Wire diameter (d) mm
 
Outside diameter (OD) mm
 
Inside diameter (ID) mm
 
Number of total coils (Nt)  
 
Number of active coils (Na)  
 
Free height (F.H.)  mm
 
Material:  
 
 

Monticello Spring Corporation
P.O. Box 705 / 3137 South Freeman Road
Monticello, IN 47960
Telephone: (574) 583-8090 / Fax: (574) 583-9299